Checking O2CB heartbeat: Not active

[root@rac01]# /etc/init.d/o2cb  status

Module "configfs": Loaded
Filesystem "configfs": Mounted
Module "ocfs2_nodemanager": Loaded
Module "ocfs2_dlm": Loaded
Module "ocfs2_dlmfs": Loaded
Filesystem "ocfs2_dlmfs": Mounted
Checking O2CB cluster ocfs2: Online
  Heartbeat dead threshold: 61
  Network idle timeout: 30000
  Network keepalive delay: 2000
  Network reconnect delay: 2000
Checking O2CB heartbeat: Not active

The Solution like the Following :

[root@rac01]# /etc/init.d/o2cb  configure

Configuring the O2CB driver.
This will configure the on-boot properties of the O2CB driver.
The following questions will determine whether the driver is loaded on
boot.  The current values will be shown in brackets ('[]').  Hitting
without typing an answer will keep that current value.  Ctrl-C
will abort.

Load O2CB driver on boot (y/n) [y]: y
Cluster to start on boot (Enter "none" to clear) [ocfs2]:
Specify heartbeat dead threshold (>=7) [31]: 61
Specify network idle timeout in ms (>=5000) [30000]:
Specify network keepalive delay in ms (>=1000) [2000]:
Specify network reconnect delay in ms (>=2000) [2000]:
Writing O2CB configuration: OK
O2CB cluster ocfs2 already online
[root@rac01]# /etc/init.d/o2cb  stop
Stopping O2CB cluster ocfs2: OK
Unmounting ocfs2_dlmfs filesystem: OK
Unloading module "ocfs2_dlmfs": OK
Unmounting configfs filesystem: OK
Unloading module "configfs": OK

 [root@rac01]# /etc/init.d/o2cb  start
Loading module "configfs": OK
Mounting configfs filesystem at /config: OK
Loading module "ocfs2_nodemanager": OK
Loading module "ocfs2_dlm": OK
Loading module "ocfs2_dlmfs": OK
Mounting ocfs2_dlmfs filesystem at /dlm: OK
Starting O2CB cluster ocfs2: OK


  [root@rac01]# ocfs2console

Then Mount Command .


  1. Looking at your steps, it seems that the only change was put 61 second to heartbeat timeout? Can you tell me what other service you have enabled?


  2. hi Harvey
    Thanks for your comment ..
    The O2CB cluster stack uses these timings to determine whether a node is dead or alive.
    While the use of default values is recommended, users can experiment with other values
    if the defaults cause spurious fencing.
    Just As Note : OCFS2 heartbeat timeouts based on storage layer I/O timeout values

  3. you need to make sure that you install the right OCFS packages for OS . its not it will never works ... you should remove and reinstall the right one .


Post a Comment

Popular posts from this blog

Connection refused; No available router to destination On Weblogic Node Manager Log

How to change SGA in Oracle Rac